Accident identification

When we takes Coordinates from GPS then we have use bps baud rate and when we have to send Coordinates to control room then we used bps baud rate. The key idea behind Thumb is that of a super-reduced instruction set.

Typically, while one instruction is being executed, its successor is being decoded and a third instruction is being fetched from memory. It has its own deterministic character.

The message is sent through the GSM module and the location of the accident is detected with the help of the GPS module.

Accident detection and alert system using arduino

Hence no need to waste time by manual operation and transportation. When we takes Coordinates from GPS then we have use bps baud rate and when we have to send Coordinates to control room then we used bps baud rate. The accident can be detected precisely with the help of both Micro electro mechanical system MEMS sensor and vibration sensor. The output pin of Vibration sensor is connected with pin number 9 of Arduino. Life of the people is under high risk. Another important aspect of the project is the Power Supply. Before you embark upon building Accident Detection and Messaging System you have to select the same baud rate of GSM and GPS device, but if you are using different baud rate module or device you will face some problem related with the baud rate. It can be configured to drive a dot-matrix liquid crystal display under the control of a 4- or 8-bit microprocessor.

This is used to adjust the contrast of the display. When the accident occurs the alert message is sent automatically to the rescue team and to the police station. It is also highly economic and less expensive; hence GSM is preferred most for this mode of controlling.

accident identification and alerting project report

How it Works Accident Detection and Messaging System is easy and the components used are Vibration Sensor, which detects the accident and in turn sends the signals to Arduino. This design is a system which can detect accidents in significantly less time and sends the basic information to first aid centre within a few seconds covering geographical coordinates, the time and angle in which a vehicle accident had occurred.

arduino based vehicle accident alert system using gps, gsm and accelerometer

An accelerometer can be used in a car alarm application so that dangerous driving can be detected. Before you embark upon building Accident Detection and Messaging System you have to select the same baud rate of GSM and GPS device, but if you are using different baud rate module or device you will face some problem related with the baud rate.

The GPS detects the latitude and longitudinal position of a vehicle. Components Required.

accident alert and vehicle tracking system project report
Rated 7/10 based on 93 review
Download
Accident Identification and alerting project